Hard Water Treatment in Midcoast Maine

Manganese

If manganese is present in the water, you may see black or brown staining on your fixtures. You may even notice a blackish-brown string or yarn type substance in the toilet tanks. The acceptable level for manganese is less than 0.05 mg/L. Typically, a Softener system will remove this issue, however, often times, manganese and iron will appear together in well water, so it is best to have an evaluation so the appropriate system is installed.

Hard Water

The hardness of water basically depends on the amount of dissolved calcium and magnesium present in the water. These minerals to create scales in cold water piping and heated water can cause a build up in water heaters, boilers, and other appliances leading to a boost in heating bills by as much as 20%. Unsightly film or scum in the tub and other fixtures may build up and may require more soap to be used for cleaning. It can build up on skin and hair and can cause dry skin, brittle hair, skin irritation and clogged pores. You may notice graying of whites or loss of brightness in colored laundry; hardness can cut back the life cycle of clothing by 35%. In addition, the calcium and magnesium will be absorbed by foods cooked in hard water and foods are more likely to shrink and become tough.
The level of hardness in water is usually expressed as grains per gallon (gpg) or milligrams per liter (mg/l). The levels are noted under Drinking Water Standards and Definitions.

Water Softener

If you have manganese or hard water, a water softener may be needed. Often times, manganese and iron will appear together in well water, so it is best to have an evaluation so the appropriate system is installed.

A softener system consists of a mineral tank containing resin, a brine tank containing salt, and a control head. A softener works through a chemical process called ion exchange. The hardness (or manganese, etc.) attaches to the ions and are removed from your water. Eventually the resin becomes saturated and needs to be regenerated (or backwashed). The control head on the softener is set to automatically backwash the filter every few days to clean out the resin inside the tank. The level of hardness (or other items found in your water) and daily usage of water will determine how often the system should regenerate or clean itself.

The resin will last for several years without needing to be replaced, but the brine tank must be filled with salt on a regular basis. Typically, one bag per month is needed and several bags may be added to last you for several months (for example, you may add 4 bags of salt every 4 months). We recommend using the green bags of softening salt that contain rust remover; 40lb. bags can be purchased at most hardware or home supply stores or 50lb. bags may be purchased at the office.

If there is a power outage, or after daylight savings, you will need to reset the timer on the control head. This is important to reset because you don't want to unknowingly use water during a backwash cycle. For instructions on resetting the timer, please follow this link:  Read more
 
softener controller-Water Treatment in Midcoast Maine
Water Softener Controller
 
solar salt-Water Treatment in Midcoast Maine
Bag of Salt
 
brine tank-Water Treatment in Midcoast Maine
The Brine Tank
 
installed system-Water Treatment in Midcoast Maine
The System Installed
 
Call Haskells Water Treatment Inc. today at 207-594-4947 or 1-800-244-4947 for more information.